VAL Avionics NAV 2000 Guía de instalación descargar pdf (Pagina 93)

SV-ADAHRS-200/201 Installation and Configuration

SkyView System Installation Guide - Revision R 5-3

An SV-ADAHRS-200/201 should be mounted within one degree of parallel to all three aircraft

axes, with the pneumatic fittings facing toward the front of the aircraft.

To ensure that the Slip/Skid Ball will be displayed as centered during flight, the SV-

ADAHRS-200/201 must be installed to 0° (absolute level). There is no adjustment in

SkyView to electronically level the SV-ADAHRS-200/201. If, after installation, the

Slip/Skid Ball is not centered, you will need to shim the SV-ADAHRS-200/201 to be

0° (absolute level). During installation, it may be necessary to use an electronic

level as a “spirit” or “bubble” level may not be able to display an accurate enough

degree of level.

The module’s mounting tabs must be on the bottom. The label must be on the top. Figure 25

shows the correct orientation of the ADAHRS as it would appear if you were above the aircraft,

looking down at it. The module will not operate properly if it is rotated or inverted in any other

orientation.

Dynon does not provide mounting hardware with SV-ADAHRS-200/201. The mounting tabs on

each side of the module have holes sized for #10 fasteners, but it is up to the installer to decide

how the ADAHRS will be secured to the aircraft.

We recommend that installers use button-head style non-ferrous (brass recommended)

fasteners in this location. Follow recommended torque practices when tightening the mounting

hardware. Do not rivet the SV-ADAHRS-200/201 to the aircraft as this will hinder future removal

if necessary.

Do not use a magnetic driver when installing the ADAHRS. Doing so has the

potential to affect the factory magnetic calibration.

SkyView Network Connection

Connect the ADAHRS module to the SkyView network using the hardware mentioned in the

SkyView System Construction Section or using equivalent hardware.

If you have to install a connector on the end of a network cable, insert all pins into the D9

connector. Refer to Appendix C: Wiring and Electrical Connections for details on connector pin-

outs and wire colors.

Remember to configure the network as described in the Network Setup and Status

section after connecting all modules to a display.

1 2 ... 88 89 90 91 92 93 94 95 96 97 98 ... 400 401

Sin comentarios

VAL Avionics NAV 2000 Guía de instalación Pagina 93