VAL Avionics NAV 2000 Guía de instalación descargar pdf (Pagina 75)

SV-D700 / SV-D1000 / SV-D1000T Installation and Configuration

SkyView System Installation Guide - Revision R 4-15

External Serial Altitude Encoder Support

Some locales may require the use of a certified altitude encoder with the Dynon SV-XPNDR-

261/262 Transponder. SkyView supports external serial altitude encoders that use

Icarus/Garmin format. When one is connected, the SV-XPNDR-261/262 uses the external

altitude encoder data source instead of SkyView’s own ADAHRS-generated pressure altitude.

However, the altitude displayed by SkyView on the PFD page is ALWAYS sourced from SkyView

ADAHRS data.

To have SkyView use an external altitude serial encoder as the pressure altitude source for the

SV-XPNDR-261/262:

 Wire a SkyView serial receive line to the respective serial transmit connection from the serial

altitude encoder. If you have more than one SkyView display, make the same connection to all

SkyView displays.

 Ensure there is a shared ground between the SkyView display and the serial altitude encoder. If

you have more than one SkyView display, make the same connection to all SkyView displays.

 Configure this serial port on each display under SETUP MENU > SYSTEM SETUP > SERIAL PORT

SETUP. The SERIAL IN device for this serial port should be set to ICARUS/GARMIN ALTITUDE.

Non-Dynon Transponder Serial Altitude Encoder Output

To use SkyView‘s altitude output functionality with your transponder that can receive serial

altitude input:

 Wire a SkyView serial transmit line to the respective receive connection on the transponder. If

you have more than one SkyView display, make the same connection to all SkyView displays.

 Ensure there is a shared ground between the SkyView display and the transponder. If you have

more than one SkyView display, make the same connection to all SkyView displays.

 Configure the serial port on each display appropriately. There is an example serial port

configuration on 4-26.

SkyView Altitude Encoder Output Formats

There must be a SkyView ADAHRS installed for the altitude encoder output to

function.

SkyView outputs its altitude measurements in two different formats. You can use either format

on any of the serial ports. These formats are described in Table 10 and Table 11. SkyView will

function properly whether or not this altitude encoder functionality is used.

ICARUS

Used by

Garmin GTX330/ES (Garmin serial port must be set to Icarus input),

Garmin GTX327 (Garmin serial port must be set to Icarus input),

Garmin GTX328 (Garmin serial port must be set to Icarus input),

Icarus,

1 2 ... 70 71 72 73 74 75 76 77 78 79 80 ... 400 401

Sin comentarios

VAL Avionics NAV 2000 Guía de instalación Pagina 75