VAL Avionics NAV 2000 Guía de instalación descargar pdf (Pagina 169)

SV-EMS-220/221 Installation and Configuration

SkyView System Installation Guide - Revision R 7-61

The alarm type for oil temperature is the “self-clearing” type.

EMS Sensor Definitions, Mapping, and Settings

All sensors must be defined, mapped to SV-EMS-220/221 pins, and have their

settings configured. This section describes how sensors are defined, mapped, and

set in SkyView.

EMS Sensor Definitions

All EMS sensor installations require a SkyView Sensor Definitions file. This file provides

characterizations of all sensors that SkyView supports, and is occasionally updated to add

additional supported sensors and correct issues with existing sensors. The most current version

of the SkyView Sensor Definitions file is preloaded onto each display prior to shipment. The

most current version of the SkyView Sensor Definitions file can be downloaded from

http://downloads.dynonavionics.com.

If you have more than one SkyView display, and the SkyView Sensor Definitions file on each

display is different from one another, a warning message will be displayed:

EMS SFG FILE MISMATCH.

If you need to update the SkyView Sensor Definitions file, download the file and use the

instructions found in the How to Load and Delete Files Section.

The SkyView Sensor Definitions file has a .sfg file extension. This file is not

automatically shared between displays. It must be loaded onto each display in the

system.

EMS Sensor Input Mapping

In order to save installers time, Dynon provides preconfigured sensor mapping and

settings files which support popular four and six-cylinder engine installations. All of

the installations mentioned in the Example Engine Sensor and Transducer

Installations Section have preconfigured mapping and settings files that are

available for download at http://downloads.dynonavionics.com.

Settings for SV-EMS-220/221 pin mapping, ranges, widget graphical properties,

etc. are automatically shared between multiple SkyView displays.

If your engine installation is listed in the Example Engine Sensor and Transducer Installations

Section, we recommend you install one of the sensor mapping and settings files onto the

SkyView display using the instruction found the How to Load and Delete Files Section. Then

update or modify the sensor map and settings based on your installation.

1 2 ... 164 165 166 167 168 169 170 171 172 173 174 ... 400 401

Sin comentarios

VAL Avionics NAV 2000 Guía de instalación Pagina 169