VAL Avionics NAV 2000 Guía de instalación descargar pdf (Pagina 289)

SV-COM-C25 Installation, Configuration, and Testing

SkyView System Installation Guide - Revision R 16-3

Physical Installation

SV-COM-PANEL – VERTICAL Installation Dimension Quick Overview

 Panel Cutout: (irregular – see drawing)

 Bezel Outline: 1.80” W x 3.532” T (45.72 mm W x 89.71 mm T)

 Note that the SV-COM-PANEL/V is sized such that two units can be stacked to

the same height as the height of an SV-D1000 display.

SV-COM-PANEL - HORIZONTAL Installation Dimension Quick Overview

 Panel Cutout: (irregular – see drawing)

 Bezel Outline: 3.532” W x 1.80” T (89.71 mm W x 45.72 mm T)

The figures on the following pages show recommended panel cutouts, mounting hole patterns,

and mechanical dimension for the SV-COM-PANEL/V (vertical) and SV-COM-PANEL/H

(horizontal). Use these diagrams to plan for the space required by the display.

To mount an SV-COM-PANEL, cut the opening in your panel, drill out the mounting holes, install

nutplates, and use the included mounting screws to fasten the display to the panel.

Your SV-COM-C25 is shipped with #6-32 hex-drive round head fasteners. Fasteners are 5/8”

long and require a 5/64” hex drive tool. Dynon recommends fastening the included mounting

screws to nut plates installed behind the panel. If access behind the panel allows, standard #6-

32 lock nuts or nuts with lock washers can be used. Do not rivet the SV-COM-PANEL to the panel

as this will hinder future removal if necessary.

The following installation procedure should be followed to install the SV-COM-425 remote

transceiver module, remembering to allow adequate space for installation of cables and

connectors.

 If you are installing two COM radios, it is acceptable to co-locate the two SV-COM-425

transceiver modules.

 Select a position in the aircraft for the SV-COM-425 that is not too close to any high external

heat source and where reasonable airflow is available. The SV-COM-425 is not a significant

heat source itself and does not need to be kept away from other devices for this reason.

 Avoid sharp bends and placing the cables too near to the aircraft control cables.

 Secure the SV-COM-425 to the aircraft via the four (4) mounting holes. The unit should be

mounted to a flat surface.

Additional items you will require for installation of SV-COM-C25, but which are not in the SV-

COM-C25 package, include:

 Nutplates for mounting SV-COM-PANEL to the panel

 Circuit breaker or fuse for power to SV-COM-425

 Power wires to SV-COM-425

 SV-COM-425 to SV-COM-PANEL wiring

 SkyView Network cables to connect the SV-COM-PANEL to SkyView Network

1 2 ... 284 285 286 287 288 289 290 291 292 293 294 ... 400 401

Sin comentarios

VAL Avionics NAV 2000 Guía de instalación Pagina 289