VAL Avionics NAV 2000 Guía de instalación descargar pdf (Pagina 140)

SV-EMS-220/221 Installation and Configuration

7-32 SkyView System Installation Guide - Revision R

Dual Engine Support using two SV-EMS-220/221s and two SkyView Displays

SkyView can monitor dual engines by displaying engine data for each engine on separate

SkyView displays. Engine #1 is assigned to one SV-EMS-220/221 module and one SkyView

display. Engine #2 is assigned to the other SV-EMS-220/221 module, and another SkyView

display. Thus, two SV-EMS-220/221s, and at least two SkyView displays are required. To set up

dual engine monitoring, go to:

SETUP MENU > EMS SETUP > DUAL EMS SETUP:

> DUAL ENGINE MODE: YES

> ENGINE #1 EMS: (select S/N of the appropriate SV-EMS-220/221)

> ENGINE #2 EMS: (select S/N of the appropriate SV-EMS-220/221)

> SPLIT FUEL COMPUTER: YES/NO. Set to YES if you want the fuel computer(s) to display

information based only on the engine assigned to the individual display(s). Set to NO if you

want the fuel computer(s) to display information based on both engines. One would normally

choose YES if the Engine #1 and Engine #2 fuel systems are completely isolated and NO if the

Engine #1 and Engine #2 fuel system are fed by a common fuel system.

For dual Rotax 912 iS with dual SV-EMS-221s that do not have individual fuel flow sensors

installed (using only CAN BUS fuel flow), set SPLIT FUEL COMPUTER to YES; setting SPLIT FUEL

COMPUTER to NO will not display correct, combined fuel computer information.

On the SkyView display that will display Engine #1 data, go to:

SETUP MENU > LOCAL DISPLAY SETUP > ENGINE TO DISPLAY > EMS #1 > ACCEPT (

On the SkyView display that will display Engine #2 data, go to:

SETUP MENU > LOCAL DISPLAY SETUP > ENGINE TO DISPLAY > EMS #2 > ACCEPT (

In a dual engine configuration, streamed EMS data (serial TX – DYNON EMS) is not

supported.

After setting up dual engine support above, changes made to engine configuration or EMS page

layout affect only that display, and the configuration of the SV-EMS-220/221 associated with it.

For example, changing a setting, or widget layout, for Engine #1, will not cause changes to

settings or layout for Engine #2.

If, after setting up dual engine support per the above instructions, if DUAL ENGINE

SUPPORT is later changed to NO, engine timer values (such as HOBBS) displayed on

the individual EMS screens will be reset. One SkyView display’s timers will

overwrite timers on all other displays.

Engine Sensor and Transducer Installation

This section explains the steps required to install and connect all sensors and transducers

supplied by Dynon Avionics. Additionally, connection instructions are given for some sensors

and transducers that Dynon Avionics does not sell, like the tachometer, fuel level, flaps, trim,

and contacts.

1 2 ... 135 136 137 138 139 140 141 142 143 144 145 ... 400 401

Sin comentarios

VAL Avionics NAV 2000 Guía de instalación Pagina 140