VAL Avionics NAV 2000 Guía de instalación descargar pdf (Pagina 49)

Basic SkyView Display Operation

SkyView System Installation Guide - Revision R 3-7

How to Reboot the Display

Press and hold buttons 1, 2 and 5 simultaneously to instantly reboot the system. This may be

helpful if you need to cycle power after changing certain settings and for general

troubleshooting.

How to Manually Adjust the Backlight Brightness or Dim Level

A SkyView display’s backlighting (brightness) is primarily controlled by its ambient light sensor.

If you have more than one SkyView display, each display’s ambient light sensor is incorporated.

You can adjust the brightness / dimming to your preference by SCREEN > DIM to access the DIM

Menu. To decrease or increase the backlight brightness press DEC- or INC+, respectively or

simply rotate the knob labeled DIM – clockwise to brighten, counter-clockwise to dim. To set

the backlight brightness to 100%, press FULL. SkyView will not allow you to dim the display(s) to

a level that would cause it to be illegible for the ambient lighting conditions.

Reference the Display Setup Section of this guide for instructions on specifying the display’s

backlight brightness control method.

How to Enter the Joystick Function Menu

Move a joystick up, down, left, or right to enter its Joystick Function Menu. These menus are

used to specify which bug that joystick adjusts if rotated. For example, joystick 1 could be set to

adjust the heading bug and joystick 2 could be set to adjust the altitude bug.

Figure 14 illustrates the joystick menu.

Figure 14–Joystick Menu

To set the function of a joystick:

16. Move a joystick up, down, left, or right to enter a Joystick Function Menu.

17. Choose the joystick function by moving the joystick up or down.

18. Confirm the highlighted function by moving the joystick left or right.

If the Map Page is onscreen, the joystick closest to the Moving Map is labeled (RNG) and is used

to adjust the map’s range. It cannot be assigned a different function.

How to Enter the Setup Menus

There are two setup menus: the Setup Menu and the In Flight Setup Menu. Simultaneously

pressing and holding buttons 7 and 8 will open one of these menus. If airspeed is zero, the

Setup Menu opens. If airspeed is greater than zero, the In Flight Setup Menu opens.

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 400 401

Sin comentarios

VAL Avionics NAV 2000 Guía de instalación Pagina 49