VAL Avionics INS 422 Manual del operador Pagina 10

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 21
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 9
VAL AVIONICS LTD
INS 429 INTEGRATED NAVIGATION SYSTEM
INSTALLATION AND OPERATOR’S MANUAL
3 SECTION III - OPERATION
3.1 GENERAL INFORMATION
3.1.1 Scope
This section will provide detailed operating instructions for your new INS 429 Integrated Navigation
System. Please read this section completely to become familiar with all of the features of the unit.
Mode Dis
p
la
y
Bearin
g
Dis
p
la
y
Active Fre
q
uenc
y
Status Dis
p
la
y
Marker Li
g
hts
Standb
Fre
uenc
Fre
q
uenc
y
Select
(
MHz
)
Fre
q
uenc
y
Select
(
kHz
)
Active - Standby Swap (Push) /
On-Off (Push & Hold)
Bearin
g
Select
(
x10º
)
Bearin
g
Select
(
x1º
)
To - From Swap, Mkr Mute (Push)/
Auto Radial Center (Push & Hold)
Figure 1: Unit Controls
3.1.2 Display Functions
The Mode display will change automatically in conjunction with the frequency that is loaded into the
active frequency position. “VOR” will appear if a VOR frequency is loaded and “ILS” will appear if an
ILS frequency is loaded. WhenEXT” is loaded in the active position, the mode display will display
XVOR”,XILS” or “XGPS” depending on the type of device that is connected to the external inputs at
the rear connector of the INS 429.
The Bearing and Status displays are contained in the upper right quadrant of the INS 429. The bearing (or
radial) will be displayed at all times in the top (Bearing) display and either “TO”, “FROM”, or “BKCS
in the lower (Status) display. If the unit is not receiving a valid VOR signal the lower display will be blank
and the CDI display will be flagged.
The unit displays a flagged condition by showing full deflection of dots in both directions. In the case of a
horizontal flag (VOR / Localizer), the CDI will show a horizontal bar indicating a flag. In the case of a
vertical flag (Glide Slope), the VDI will show a vertical bar indicating a flag.
The marker receiver is always operational and the marker lights are located horizontally in the lower right
quadrant of the unit’s display.
Original Issue Page 10 of 21
August 2008
Vista de pagina 9
1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 20 21

Comentarios a estos manuales

Sin comentarios